Wednesday, 6 February 2013

Pretty Petites gift card holder




























This cute little gift card holder uses 1/2 sheet of  A4 CS & 2 pieces of DSP that measure 7 x 10cm to decorate the front & inside.
Instructions:
Fold your CS in 1/2 as you would a std card then open & fold in 1/2 again the other way so you end up with 4 rectagles.















Fold the card in half (folded edge is along the bottom) & cut a triangle 2 layers of CS at once as shown in pic.













 



Place cut off triangle piece folded in the embossing folder, & run through the bigshot with no tabs.
Tip: Trim the longest edge of the triangle a little prior to embossing or you will have to trim all 3 points to fit nicely as pockets in the holder later.
Apply sticky strip to the 2 edges shown in pic below & adhere the triangle embossed piece so it is in place on the sticky strip then fold up the card holder & adhere to form the 2 pockets.



























Adhere the DSP to the front, cut the other piece in half diagonally & adhere those to the inside.




Tie some ribbon/twine around the entire front piece to keep the middle triangle piece in place as it is only adhered with a small amount of sticky strip, it will also keep your gift card from falling out.


Decorate as desired. Holds a tea bag & note card nicely.

1 comment:

andrea merlin said...

Very cute! I am alwqys looking for cute ways to give gift cards, I pinned to try later. Thanks for the inspiration and the pretty example.